new TPS , wont stay running

[rmdrake]

installe the new TPS today and set it using tune ECU .6 volts for tps went through the steps set the stepper moter at what it recomends , it was running rough, then that smothed out , then it went to dying on me at stop lights , what am i missing here supposed to leave in the morning to new braunfels, thinking i screwed something up , HELP ME PLEASE

 

[warp9.9]

I posted this on your other thread you can PM owl and he can remove this one if you ask since people are starting to make suggestions on the other thread.

When you installed the TPS did you just reset adaptives or did you click on ISV reset. If the former you must read all the directions on the bottom of the screen they move by quickly. But you have to verify the TPS voltage went up to like .7 or .72 and if not adjust idle stepper motor till it does then go back and hit reset isvc again. I might noy be totally right as I do not have a stepper motor on mine but it is on the screen. Hope this helps.

 

[tdragger]

posted on other thread.