KnN pods

Nat67 said:

After 5 years my Ramair filter is getting shabby to say the least . I am considering the pros and cons of fitting pod filters thru a cut bear claw , a look I really like . The KnN 40-40s would be the best bet but I have a left knee snagging problem . To this end , I definitely need an offset flange , the only ones I can find are the RU 1770s with a 20 degree offset. Has anyone used these ? I'm not sure the airflow would be enough with the shorts , which are 4 inches or thereabouts , so considering the 6 inch ? Any help here guys would be greatly appreciated !

Click to expand...

CamaroCarl said:

I used 3 tapered K and n's with an angled base. Have them turned up a little more now than the picture shows. My knee clears alright, but I'm only 5'6". Don't remember part numbers.

Click to expand...

sleeves said:

Hi Nat

My 4040's are set up like this using silicone hoses and some carefully cut PVC pipe from our workshop however even tipped forward my knee still does hit them but its a compromise I'm prepared to live with.

When cutting the blue hoses the trick is that every pipe is a different length.

For the record if I was sensible I would refit the bear claw and use the 2780's. Have done this on my "stock" R3.

Click to expand...

barbagris said:

Nat - on a standard block a RAMAIR flows more than enough. But aesthetics may dictate other options. If you go for fully exposed K&N - make sure you fit the rain covers. Apart from the obvious plus - they will reduce the clean/re-oil frequency. And should help keep your knee cleaner.

My POV is that leaving the claw on is what keeps my left knee clean-ish. Have tried all sorts of open filter and always end up with a well oiled left knee.

Click to expand...

Tal said:

Hi Nath...i have these 2780 jobbies...We cut the bearclaw away with a cutting disc which if you take your time, works well.
I have some home made aluminium inserts glued in there with araldite...a cobber of mine used some axle covers off an old Harley on his. It fills the recess nicely. They dont interfere with the knees too much either.

Click to expand...

mully95 said:

You could get a supercharger kit and the way the piping runs it won't hit your leg

Click to expand...

Nat67 said:

Great to hear from you Tal , it's been too long . I think you nailed it there mate . Also , I see you have not had to relocate the recovery tank . Do you have a part number for the filter on the AIT?

Click to expand...