Jetstream indicators and i.nex from Kellermann

One last question for BlackBandit, you should start charging by the hour lol!
How did you manage to secure the jetstreams on and inside the original indicator holders on the front? Did you use an adapter of some sorts and did you burn or cut away some plastic on the inside of the holder to secure the large bolt that comes with the Jetstream? Curious to know ...thanks! I will post photo's or video when it's done.
 
So, I ended up using these extra adaptor plates. May be not necessary but it gave extras length to the structure and reduced length from the bolt.
1770837063107.png

Luckily I didn't have to cut or burn anything on the inside of the indicator holder. I found it tricky to get them off, but applied a lot of heat and moved slowly, and the job was done.
 
Last edited:
Hi Guru,
I'm on business travel this week - apologies for the delay in answering.
I did nothing special besides using some threadlocking adhesive. And if I remember correct, with the Indicators came some little metal plates for the outside, where the indicators are sitting on. I had no issue with too few space, except it took a minute longer to turn the nut on the screw...
 
Hi Guru,
I'm on business travel this week - apologies for the delay in answering.
I did nothing special besides using some threadlocking adhesive. And if I remember correct, with the Indicators came some little metal plates for the outside, where the indicators are sitting on. I had no issue with too few space, except it took a minute longer to turn the nut on the screw...
Thanks for answering! I'll post a video in a minute.
 
Progress: waiting on posi lock connectors to make the final connections and then covering everything up.
It is unbelievable how bright these lights are, but video or photo doesn't do them justice.
1770909694830.png

Inserted two video's: one with garage lights on, and one off, but when it is completely finished I'll try to make in complete darkness.
 
Back
Top