Ignition Switch Mystery Cable

TroyAndEddie

Standard Bore
Joined
May 6, 2013
Messages
8
I replaced the dummy switch on the ignition as part of the Eastern Beaver relay kit, and noticed there is a white 2-pin connector that's now connected to nothing, and I can't remember if it ever was connected to anything. Everything on the ignition switch works as it should, and I can't find a place for this mystery connector, so I'm assuming it was in the switch before and I just didn't notice when I pulled it apart. It won't fit now due to the LO-cut wiring I installed on the new switch, so unless anyone tells me different, I'm just going to assume it's extra and I'll throw some heat shrink on it to protect it from the elements.

Any ideas?
 
Wasn't the heated grips, they came on just fine. The 2 wires are green/yellow stripe and black/yellow stripe. Here's a pic for curious minds.
 

Attachments

  • _DSC1187.JPG
    _DSC1187.JPG
    96.7 KB · Views: 53
If all your acessories still work and no check eng light :) Maybe for alarm ? . One of these guys will probly have a wireing diagram to check. There are some realy knowledgeable guys on here
 
It certainly has me stumped. I looked over several wiring diagrams and could not find a wiring combination that matches this connector. But it is coming out of the factory heat shrink tubing. Very strange.
 
Nope, none of those. I have all those factory accessories installed (and working properly), minus the alarm. Tank is full right now; when it gets a bit lower, I'm going to lift and trace the wires back to where they originate to help solve this puzzle.
 
Back
Top