hp/torque mods and dyno sheets
My secondaries were supposedly already open at the top end (using TuneEcu) but the knee was still there. Anyway, after handing my Rocket over to our regional tuning kaiser, the knee was gone.
So I am not really sure, maybe I didn't get it quite right with TuneEcu on the first hand.
 
Good info. I have a tuneecu cable, but have never hooked it up yet. I bought an auto tune also, which isn't on the Rocket yet either. My plan was to open the secondaries at the top end and anywhere else they are closed, except the bottom end of first, as I don't like too much drama at parking lot speeds. Debating about a crossover, a crossover plus CES headers, CES full exhaust, or a Carpenter pipe. The RX-4040's also look interesting. Then I would get it re-dyno'd in the end.
 
Hi bob I just put your tune on my 2008 touring with d and d pipes and ram air, can’t wait to ride this weekend.
 
You must log in or register to reply here.

Similar threads

Would like to ride the ultimate torque machine, is this a good deal?
2 3
Replies
22
Views
2K
Ronmold
Which sensors disable ignition and injection?
2 3
Replies
22
Views
1K
TURBO200R4
Tall guy mods?
Replies
5
Views
820
Mike188
What’s everyone running for clutch and where did you get them?
Replies
8
Views
476
Gerald
Looking for oem tank and knee pads
Replies
0
Views
265
Earthquake
Menu
Log in
Register