Markx
.020 Over
- Joined
- Jan 29, 2015
- Messages
- 27
- Location
- Knoxville, Tennessee
- Ride
- 2013 Rocket Roadster, 2005 Yamaha FZ1
This is probably very easy but I am nervous about loosening the engine mount bolt to install the bars. Should the motor be supported if the nuts are taken off? Of course I would do one at a time. I know that the torque on the bolt should be 60nm, but what if you are off a little on that. My torque wrench is not very high tech, it just the bar type which I do not think is very accurate. I appreciate all comments.