Loaded TB today - no problem
Loaded USB driver for TB cable - no problem
Here's a shot of my laptop device manager:
Followed instructions and connected ECU to cable and USB to laptop, then opened the TB Tune Editor and turned on bike with kill switch on run (BTW, does it matter if the bike is in gear? Just realized I never tried this in neutral - and would that really make any difference?). Opened Properties and set COM port:
Closed the TB Editor and restarted it. Went to Get ECU Serial number, saw the light flashing on the plug connected to the ECU and got this message:
Okay, fine - I'll just reset the Wait Time
I tried this at 30, 25, 20, 15, 10, 5, and zero with no luck - even tried 35 (and each time I opened and closed the Editor)
I'm hooked up to a tender and can't figure out why I'm not connecting - can anyone help me with suggestions short of trying this all on a different laptop?
Thanks
Loaded USB driver for TB cable - no problem
Here's a shot of my laptop device manager:
Followed instructions and connected ECU to cable and USB to laptop, then opened the TB Tune Editor and turned on bike with kill switch on run (BTW, does it matter if the bike is in gear? Just realized I never tried this in neutral - and would that really make any difference?). Opened Properties and set COM port:
Closed the TB Editor and restarted it. Went to Get ECU Serial number, saw the light flashing on the plug connected to the ECU and got this message:
Okay, fine - I'll just reset the Wait Time
I tried this at 30, 25, 20, 15, 10, 5, and zero with no luck - even tried 35 (and each time I opened and closed the Editor)
I'm hooked up to a tender and can't figure out why I'm not connecting - can anyone help me with suggestions short of trying this all on a different laptop?
Thanks