Another idle problem

I'd like to ideally get it back to stock and working properly.
Any ideas on how to make that happen?

I am with u on getting it back to stock.
Make sure that u have play in the throttle cables then spray linkages with wd40 especialy the area where the cables go around the cams close to the stepper motor. Then do wot letting the throttle snap closed a few times
It is not uncommon for the idle to stay high for a few seconds when u first start.
If still having
 
I just hate posting using my phone
Will try to finish
Check the 3 vac lines at the throttle bodys to the/and connector then to map sensor
Hth
 
Back
Top