Search results for query: *

  1. Steve Barnes

    Coil Issue

    I found I accidentally knocked off a Coil connector on Number one (big thanks to R3 Owners forum and TUNE ECU helping me through that), Bike was running fine till I tried to take her out for a test run. As soon as I tried to take off, same thing, no power, ran rough and engine light on. Hooked...
  2. Steve Barnes

    Engine Light On, No power

    UPDATE.. ALL IS WELL Cant thank you guys enough. Long story short. Looked at code in mqnual and followed instructions. Looks loke i knocked a lead connector off the front coil while servi
  3. Steve Barnes

    Cylinder numbering

    Thank you
  4. Steve Barnes

    Cylinder numbering

    Thank you
  5. Steve Barnes

    Cylinder numbering

    have a code on my tune ecu for coil on number one. Ok. Been looking online and in the manual for an hour and can not find which cylinder is number 1,2 or 3. Someone please tell me
  6. Steve Barnes

    Engine Light On, No power

    Ok, broke down and purchased the tune ECU kit and went through about two hours figuring it our and downloading everything drivers etc. The diagnoses came back with 2 codes first, PO560 ECM power supply circuit malfunction, Next was PO351 Ignition coil circuit malfunction. The first code...
  7. Steve Barnes

    Engine Light On, No power

    I've disconnected the negative post for approximately 20 mins, I'll try it for overnight and see what happens. Not sure exactly which strand the bad relay was but have since replaced with new relay, I have a Tune ECU on it's way, Thank you for your assistance
  8. Steve Barnes

    Engine Light On, No power

    No obstructions, she's breathing fine
  9. Steve Barnes

    Engine Light On, No power

    I believe its the wire for the auxiliary front lights. Thats the only thing i cant get to work on the bike. All other lights,horn,starter etc work
  10. Steve Barnes

    Engine Light On, No power

    appreciate that thank you
  11. Steve Barnes

    Engine Light On, No power

    I was doing general maintenance when I replaced the shroud over the air cleaner. The screw caught a wire sitting just to the front of the opening and I saw a spark. Immediately pulled wire open (four wires in bundle) finding damage to the red wire. Fixed the wire, checked others and bike...
  12. Steve Barnes

    ignition switch replacement

    I need to install my new ignition switch. I need advise on how to preform this surgery before pulling everything apart. I installed the EB kit without a problem but when looking around, it seems there must be a trick or two involved with getting the old one out and new one in. Locating the...
  13. Steve Barnes

    Possible Ignition Issue

    I have a 2005 beauty. She is beginning to have an electrical issue. This weekend, I fired her up and all was well but died within two to three seconds where everyting was dead, no lights nothing. I turned the key off then back on and nothing, No lights no sweep. I turned the key off and I...
  14. Steve Barnes

    FTR2: Why we do it.

    Very well done, passion is a great part of this hobby (obsession) this piece shares some of that passion in my humble opinion
  15. Steve Barnes

    New shirt idea ?

    Looks good to me,,one can or two
  16. Steve Barnes

    Pushed it a bit too hard

    Peg grinding takes on a whole new meaning on the big bikes
  17. Steve Barnes

    New Here!

    Congratulations on a beautiful new bike,, just took a short ride on mine wishing for warm weather,, enjoy
  18. Steve Barnes

    Different starting issue.

    Forgot to thank you for the very helpful info, saved me some time and aggravation. Cleaned and greased up the switch, also had just a little corrosion on the negative battery post. Did the job and have had no problems since. Will be putting in the Easter Beaver Kit soon, Thanks again and...
Back
Top