Recent content by Andy Brooke

  1. Andy Brooke

    Final drive maintenance..

    Will you be doing the splines behind the cush drive too Martin?
  2. Andy Brooke

    2.5 rear swing arm bearings.

    Has anyone had these bearings regreased/checked? If so at what milage is recommended? On the 2.3 it was about 20 k..
  3. Andy Brooke

    Outer Cush Drive Assembly

    My manual says 110nm? Rear Wheel Nuts 81 lbf ft (110 Nm)
  4. Andy Brooke

    Final drive maintenance..

    Journeyman, do you also remove the cush drive and grease the inner splines?
  5. Andy Brooke

    Final drive maintenance..

    Just done it... luvley jubley.... Cheers Journeyman.. Can I assume that the bevel box runs in oil so those gears need no maintenance?
  6. Andy Brooke

    Final drive maintenance..

    Thanks for the replies.... But how do you grease the splines when as far as I know the unit is sealed? Has anyone seen a video showing how its done?
  7. Andy Brooke

    Final drive maintenance..

    Coming from a 2.3 to the 2.5, I wondered if anyone has figured out how to grease the drive splines inside the final drive? Or is it not something that needs doing on the 2.5s? Do the splines run in oil?
  8. Andy Brooke

    Pillion peg bolts

    (21 GT) Would anyone know the torque setting on the pillion peg bolt. My wife uses the pegs to climb on and off so just need to know that theyre still torqued up. to spec..
  9. Andy Brooke

    Pulled the trigger on R3 Storm GT yesterday...Not too impressed with dealer about options to add.

    I found the quick shifter to be no better than clutchless shifting........UNTIL I found it wasnt enabled in the menu duh!!!!!
  10. Andy Brooke

    Can the R3 be jacked up from a lifting point to get rear tire off the ground?

    I have the "expensive Big blue with the R3 lifting kit for wheels out , but also use cheaper bike scissor lift just to clean the wheels. https://on-bike.com/motorcycle-lifts/triumph-rocket-3r-gt-2020-onwards
  11. Andy Brooke

    Will a ram air and tune ECU make much difference?

    Speak to Carl at Just Rocket https://justrockets.co.uk/
  12. Andy Brooke

    Mel suter

    Try Carl Inkley at https://justrockets.co.uk/
  13. Andy Brooke

    Comment by 'Andy Brooke' in media 'GIVI Top Box'

    You can get a universal fit fitting plate from Givi, that will take the mono key boxes.
  14. Andy Brooke

    Hello - From Lincolnshire, England

    If you need any help with the bike , give Carl Inkley a shout at Just Rockets in Spalding https://justrockets.co.uk/
  15. Andy Brooke

    STARTER UPGRADE

    You could do worse than ask Carl Inkley at Just Rockets https://justrockets.co.uk/
See more
Back
Top