Throttle bodies sync.

Used TuneECU for the first time today. Checked my throttle bod sync as I suspected it maybe out (one cylinder sounded a bit lazy/out of sync). They were a long way out so went about syncing them.

The adjusting screws were very hard to get at even with a very long screwdriver. In addition the screw between 1 and 2 seemed to work in reverse to that between 2 and 3 whch took a while to figure out. It took well over an hour to sort but was woth doing if nohing other than knowing it right now.

I also loaded a new tune from the Meister to suit my RamAir and Tors. What a difference. It's added a whole new level of power and response. Superb.

Yea they are a pain those pesky screws . I bought a long flexy drive screwdriver , works a treat and with a 3mm hex bit is perfect for reaching the throttle bodys clamps also ! Glad to hear it all worked out well , I bin on a similar journey myself this last couple weeks !