SuperCharger w/ partial bearclaw, will it fit?

[Leif Almberg]

come winter I will install the TTS Supercharger on my Roadster.
I am very fond of Nigel Rodger's carbon fibre partial bear claw.

this bear claw fits nicely over triple KNs and such, not blocking or heating the air as the full stock bear claw does.

However, does anyone have Nigel's partial bear claw along with the super charger? I have to know if the intake fits under the bear claw, can't buy on chance..

thanks in advance!

 

[Pedro]

the stock one fits just as it always did.no problem .dont no about this one

 

[scot in exile]

As agreed upon in a previous post we are swapping bikes so any mods you put on the bike are at your cost I do not mind you installing all the extras but I am not paying for them.

 

[Leif Almberg]

the stock one fits just as it always did.no problem .dont no about this one

thanks. if the stock one fits over the supercharger, then a partial would of course fit!

 

[Leif Almberg]

As agreed upon in a previous post we are swapping bikes so any mods you put on the bike are at your cost I do not mind you installing all the extras but I am not paying for them.

we will only swap if mine is the slower one!
after the supercharger I really hope to give you guys some dust to eat

or, what the heck, shall we swap anyway! but we will split the shipping...