Motorcycle Lifts/Jacks

[albertaduke]

there're real stable.
I drill the hole to attach the little piece of rope
for a couple of different reasons.
1) so you can see it hanging down under the bike when you get her off the lift,
and remember to take them out of the holes.
2) to hang them over the handle of the jack when not in use so they stay together.

I can vouch for the set i got three years ago how time fly!!! right skip!!

 

[motolink]

Is there anyone in Australia making the babies and wants a few dollars to make an extra set.

 

[Rexrocket]

Harbour Freight

I was looking and Harbour Freight had one on sale that I like better than the two ATV Cycly lifts i all ready had.
This lift has two arms that go under what you want to lift.(like fork truck)
Hand pump up to 40" lift if you need to.
Imstall the saftey pin then go to work.
Works great on my low 1979 Electrode Guide.
If I was to get another lift this woulfd be the one.

I've been researching motorcycle jacks. On most Sears models I read a bad review for every 3 good reviews. Same for jacks from Northern Tool and others. I'm currently looking at the Pro-lift T-2151 1500lb lift. I haven't found many reviews on it yet. Please share your experiences and recommendations. Of course these jacks are for my RT3 Beast.

 

[xhdskip]

I can vouch for the set i got three years ago how time fly!!! right skip!!

yep, you've had yours forever.
I'm not even sure I was putting holes into them for the little rope yet then.
Didn't start that till a few folks had forgot to remove them and lost one or two.

 

[albertaduke]

yep, you've had yours forever.
I'm not even sure I was putting holes into them for the little rope yet then.
Didn't start that till a few folks had forgot to remove them and lost one or two.

nope no holes. but never forgot to remove them as they were holding the bike on my homemade lift table.I did post a pic of that table with the bike on top and the set under the frame .

 

[Mittzy]

Is there anyone in Australia making the babies and wants a few dollars to make an extra set.

If Skip can measure them and send me the dimentions i will make ya a set (If I have the materials)

 

[Elvis]

I looked at one of these "live" today, it worked great on a Harley and Yamaha stratoliner but since we don't have the same type of rails I was afraid to try mine until verifying where the lift points would, anyone have experience?

Pitbull Motorcycle Lifts Product Review - YouTube