Bearclaw front bracket?

mexican

Living Legend
Joined
Jul 22, 2010
Messages
14,671
Location
Tulsa OK
Ride
2012 Carpenter Silver BACK240
Hey gurus, last year i took the bearclaw off to fit the K&N filters, i put it up for future use.
Today, i installed tge Ramair system and tried to put the bearclaw back.
The rear bolt lines up, the rubber center tabs lines up, the front hole on the bike is about 2” back from the hole on the brarclaw, did i lose a small bracket somewhere? Does snybody have pics of what it looks like snd where to get it? Thanks in advance
 
Sorry amigo I just ride em. I don’t know what makes em go. This bump might bring some worthwhile help.
 
I have a Touring with the Ramair, so I don't know if it's that same as the roadster, or as your avatar shows, the Rocket X.
On my bear claw, there is just one bolt in the front, the middle and back have "rods" that fit into rubber grommets. It is always a trick to get the center rod into the grommet and that keeps the bolt hole from wanting to snug up. At the back near the seat a little bit of the filter foams peeks out, too, but only I know it's there.
 
You must log in or register to reply here.

Similar threads

Front tire woes.
Replies
3
Views
1K
Kevin frazier
2014roadster front brake pads
Replies
7
Views
2K
oteczdmitriy
Front crash bars wanted
Replies
0
Views
1K
bebsy
Front wheel chock / stand
2
Replies
16
Views
3K
Navigator
Lift bracket for a Roadster
Replies
2
Views
1K
Nat67
Menu
Log in
Register