Bearclaw front bracket?

[mexican]

Hey gurus, last year i took the bearclaw off to fit the K&N filters, i put it up for future use.
Today, i installed tge Ramair system and tried to put the bearclaw back.
The rear bolt lines up, the rubber center tabs lines up, the front hole on the bike is about 2” back from the hole on the brarclaw, did i lose a small bracket somewhere? Does snybody have pics of what it looks like snd where to get it? Thanks in advance

 

[Dr.D]

Sorry amigo I just ride em. I don’t know what makes em go. This bump might bring some worthwhile help.

 

[mexican]

Sorry amigo I just ride em. I don’t know what makes em go. This bump might bring some worthwhile help.

Thank you, hopefully somebody will know the answer

 

[TURBO200R4]

I think that there is a bracket that goes there.
I can snap a pic tomorrow..

 

[Starmanut]

I have a Touring with the Ramair, so I don't know if it's that same as the roadster, or as your avatar shows, the Rocket X.
On my bear claw, there is just one bolt in the front, the middle and back have "rods" that fit into rubber grommets. It is always a trick to get the center rod into the grommet and that keeps the bolt hole from wanting to snug up. At the back near the seat a little bit of the filter foams peeks out, too, but only I know it's there.

 

[ozrider]

@mexican Here you go

 

[TURBO200R4]

bump

 

[TURBO200R4]

bump

 

[mexican]

Thanks guys, we got it figured our, see the above post from @ozrider

 

[mexican]

Thanks Herman, that is the photo i needed to see how it sits there