2018 Rocket So Far

BDClone

.040 Over
Joined
Feb 1, 2019
Messages
63
Location
Pineville, Louisiana
Ride
2018 Rocket III Roadster
The first pic should be my stock baseline dyno at 121 HP and 138 ft-lbs of torque. The second is with Ramair, Carpenter Sidewinder exhaust, HansO tune from the resourse section. 147 hp and 147 ft-lbs of torque Hans0 2014+ Roadster unrestricted plus 10%
The final one is after fine tuning on dyno 152 hp and 158 ft-lbs of torque. I will have to see if I can up load the new map later. I dont know anything about uploading a map so any advice would be appreciated.
 

Attachments

  • 20190515_144317.jpg
    20190515_144317.jpg
    184.5 KB · Views: 5
  • 20190515_144327.jpg
    20190515_144327.jpg
    175.8 KB · Views: 6
  • 20190515_144343.jpg
    20190515_144343.jpg
    177 KB · Views: 5
Hey Clone.... nice numbers. Thanks for posting.

I noticed that the air/fuel ratios aren't showing for the first 2 dyno posts while the 3rd seems to be around 13.5 to 1. Do you know how rich/lean Hanso's tune was for the second run?
 
Hey Clone.... nice numbers. Thanks for posting.

I noticed that the air/fuel ratios aren't showing for the first 2 dyno posts while the 3rd seems to be around 13.5 to 1. Do you know how rich/lean Hanso's tune was for the second run?

It was at idle and the higher end but the middle 2000 to 4000 rpm was rich. My gas mileage was terrible. We just quick pulls for stock and with the HansO tune. We didnt do A/F till we started retuning. I didnt think about getting the printout for that first run. We just ready to start remapping.
 
Back
Top