火箭三R中气缸压缩为零。有人知道原因吗？

[JAPANユーザー]

which tool you used to check the compression?

what are the values for other two cylinder for compression?

This is the one I used. The other two cylinders have an air pressure of 8-9 kg.

 

[Journeyman]

Could you give us more information on your situation- the bike, what happened to lead you to doing a compression test.

 

[JAPANユーザー]

Could you give us more information on your situation- the bike, what happened to lead you to doing a compression test.

When I started the car, I heard an unusual exhaust sound and the instrument panel light came on. The computer detected the fault code P0068. I touched the exhaust pipe and the middle temperature was very low, so I concluded there was a problem with the middle cylinder. Test results: The compression value of the middle cylinder was 0.

 

[Journeyman]

When I started the car, I heard an unusual exhaust sound and the instrument panel light came on. The computer detected the fault code P0068. I touched the exhaust pipe and the middle temperature was very low, so I concluded there was a problem with the middle cylinder. Test results: The compression value of the middle cylinder was 0.

Un huh- what kind of "car?"

 

[imcool]

Un huh- what kind of "car?"

I think he is using translator, he meant Rocket for sure.

 

[imcool]

This is the one I used. The other two cylinders have an air pressure of 8-9 kg.

your guage is in kpa,

you saying that you got 8-9kg.

did you mean you got 800 to 900kpa ?

 

[wjb]

A leak down test will pressurize the cylinder. Air escaping the intake tract could indicate a leaky or bent intake valve. Air escaping the exhaust can indicate a faulty exhaust valve. Air escaping the crankcase breather can indicate faulty rings or piston. Air escaping around the clutch cover usually indicates aliens in the clutch.

 

[Journeyman]

I'm watching this post to see where it goes

The new Rockets have decompressors. These keep the exhaust valves open before startup to make turnover easier. I suspect that might be the case here. This drove me crazy when I was first checking valve clearances, as some were waaaayyyyy to open. If the cylinder in question is in position for the exhaust valve to be be closed while running, but it is not running, that valve will be propped open and that would give you zero compression.

A look at the 2.5 Innards - DIY 20K mile service, including valve clearance check and shim replacement

I am curious as to how much it holds down those exhaust valves Measuring with and without would give us the answer if possible?

www.r3owners.net