R-III-R Turbo
Mine is the biggest :)
- Joined
- Oct 12, 2010
- Messages
- 2,513
- Location
- Ireland
- Ride
- 2472cc Supercharged Carpenter Rocket III Stroker
Jim the rocket
Standard Bore
- Joined
- Jun 17, 2026
- Messages
- 6
- Ride
- 2008 Rocket 3 and an 05 Soft tail
I would also like some input on the wave washer it is about 15mm inside and the shaft is 13mm, the other end where the roller bearing is on is 17mm? Should I be concerned or is this difference the same on all of them, just doesn't seem right?
Jim the rocket
Standard Bore
- Joined
- Jun 17, 2026
- Messages
- 6
- Ride
- 2008 Rocket 3 and an 05 Soft tail
Thank you I will look into getting the other shaft, sometimes it's a little pricey over here on the other side of the pond.
R-III-R Turbo
Mine is the biggest :)
- Joined
- Oct 12, 2010
- Messages
- 2,513
- Location
- Ireland
- Ride
- 2472cc Supercharged Carpenter Rocket III Stroker
Yeah that's ok, the wavey washer goes between the pullrod and the clutch nut on input shaft, to dampen the pullrod bouncing around. The pullrod needs to have play when lever not pulled so as to not interfere with clutch pressure.
