Recent content by v*twin

  1. For Sale 05 Classic parts clean out

    sold...

  2. For Sale 2005 Rocket Classic

    Sold...

  3. For Sale 2005 Rocket Classic

    Model:2005 Classic Mileage: 32000 Motorcycle Location:47201,Indiana Tile: Clean Title in hand Asking price: $4000(note: motorcycle was involved in a accident) I have owned the motorcycle for last 6 years and have put on almost 20k miles. I skid off road couple of months ago and damaged the...

  4. For Sale 05 Classic parts clean out

    I was planning to use this parts to build a electric motorcycle but have too many projects on hand & would like to sell all this parts together as one sale. Asking $1000 for sale of all the parts below Chassis ( no title ,have bill of sale from previous owner).Appears true and not damaged Front...

  5. Transmission issue

    Used the timing marks on crankshaft gear as Scott had mentioned but didn't notice a dot mark on cam lower chain sprocket gear .

  6. Transmission issue

    I took good advice and did some checks before taking clutch over OFF. Not sure what it was hydrostatic tension or oil temperature it was weird after I had engine running for couple of minutes, with multiple starts & stops. CLUTCH WORKS NOW!!! Took bike for a spin around the block , shifted...

  7. Transmission issue

    The only thing I was not sure of is the orientation of Clutch basket bearing sleeve, I had it installed with the 4 cross slots facing towards clutch pressure plate Yeah, only parts changed on transmission were the output shaft gear and output damper but left all clutch and gear selector...

  8. Transmission issue

    The only thing I was not sure of is the orientation of Clutch basket bearing sleeve, I had it installed with the 4 cross slots facing towards clutch pressure plate

  9. Transmission issue

    There is no marking on the lifter shaft arm but there is the dot mark on the shaft. Currently the shaft arm is at the same position as in the photo aligned with shaft marking. I had some luck, was about to pull battery out to get a new replacement battery and decided to jump start one last...

  10. Transmission issue

    The clutch system has all stock components and made sure I installed the plates back same orientation as I had taken them out.The plates were oiled and springs torqued to 10nm . After installation of pressure plate had checked lifter piece action but I couldn't move the pressure plate back.I had...

  11. Transmission issue

    Installed engine and assembled bike over the week but when was ready to start & test engine have couple of issues. >The clutch plates doesn't seem dis-engage even though lifter piece appears to pulling the clutch pressure plate.The linkage appears to be pulling the lifter piece as the tension...

  12. Transmission issue

    Thanks Scott, I had over looked the spare parts illustration diagram, found the spring orientation for non return valve Then proceeding with assembly,can't seem to find the "dot" mark the timing chain-crankshaft gear.Is the marking typically on gear very distinct or am I missing something...

  13. Transmission issue

    Scott, Does the spring (photo attached) goes into the port aswell.

  14. Transmission issue

    Finally got all the parts and in process of putting back engine together.I cant seem to recollect where this spring went but was along with oil pan parts bin.No luck looking finding spring location in parts diagram or service manual either. Does this spring go under bottom side of non -return...

  15. Transmission issue

    Finally the parts were delivered but I have forgot to place order for cam timing tool. I am hoping I can borrow the tool from one of you guys. I can order a new tool and have it shipped to you .I would really appreciate it and not having to wait couple more weeks waiting on the tool
See more
Back
Top