New profile posts

What's new New posts New media New media comments New resources New profile posts Latest activity
Titanium
Look me up on FB to see some of the videos posted of our rides on Tail of the Dragon, The Snake, Rattler etc...
Lemieuxfan
hey i'll sell you my factory leather pannier bags
Wade'sWorld
Wade'sWorld
Thanks for the offer, but things are on a bit of a hold for bike accessories for now. Selling our house and have to put extra money into that.
Thanks again, Wade
Buck182
Bit of advice please, just installed the Ramair filter. Now have an engine light, anyone had a similar issue after doing this mod.
scot in exile
scot in exile
run the bike for quite a few miles the light will turn off.
Tattoomick
Do you still have tors and link pipe ? If so how much and will they fit 2013 roadster? Thanks pal.
Tattoomick
Stavros do you have flags on the back of your bike? Drove past a bike like yours in Batley buy it had flags on the rear, was this you pal?
stavros
stavros
hi tattoomick. no, not me mate . not been out on it this year
mot runs out tomorrow, so hoping to get out tomorrow and get it tested
Mrbuickstage1
Just replaced tire bearing tight on brake side removed drive hub inside tight also do you or any one know what or where I can get bearings looks like 3 total ?
warp9.9
warp9.9
To be honest I just changed one of the rear bearings in my 18 inch rim. The inside double roller had a damaged seal. Like everyone else the were tight until I removed them. I just called one of the local bearing distrubutors, Motion Pro. And they had cheap ones in stock. Or great ones he could order. So I ordered one and dropped it in. I have used dealers, but there is none within 200 miles.
Hello from Arizona. I have a 2010 Roadster that has a Supertrapp muffler (open end cap)/stock header, deleted secondary throttle plates, triple K&N filters. Is there a map that you'd recommend for my setup using Tuneecu? Thanks!
dmc101290@aol.com is my email.

Respectfully,
Dan
Back
Top