Video on greasing rear needle bearing

[mo8414]

They have ones that will screw right onto the grease gun also. FYI Milwaukee makes a nice 12v grease gun, I'll never use a manual one again.

 

[DukeR3]

Wanted to say thanks to the OP...

-new rear tire
- Oil and filter
- New oil final drive
- Lube drive shaft splines
- Flush brake resiviour
- re move read pads - clean - push pistons back - (fluid out nipple) - not back up ABS
- Spray drive shaft ACF50 - rust prvention.

Great Idea on the - BBQ thing.. I shortened the needle part, drilled the hole in the syringe larger to reduce the effort to push the grease out.
Worked a treat.

Magnets to pull the bushing out.. another great idea..!

Yep dry as a bone..

Modified for the job...

Carefully squirt some grease around the bearing, then push it in to the rollers.. job done.

 

[Claudiu]

Wanted to say thanks to the OP...

-new rear tire
- Oil and filter
- New oil final drive
- Lube drive shaft splines
- Flush brake resiviour
- re move read pads - clean - push pistons back - (fluid out nipple) - not back up ABS
- Spray drive shaft ACF50 - rust prvention.

Great Idea on the - BBQ thing.. I shortened the needle part, drilled the hole in the syringe larger to reduce the effort to push the grease out.
Worked a treat.

Magnets to pull the bushing out.. another great idea..!

Yep dry as a bone..

Modified for the job...

Carefully squirt some grease around the bearing, then push it in to the rollers.. job done.

I am only adding that I use the needle with holes along, like a flute. The tricky part is to squirt only “some” grease so the rollers don’t into a hydraulic break

 

[mo8414]

Wanted to say thanks to the OP...

-new rear tire
- Oil and filter
- New oil final drive
- Lube drive shaft splines
- Flush brake resiviour
- re move read pads - clean - push pistons back - (fluid out nipple) - not back up ABS
- Spray drive shaft ACF50 - rust prvention.

Great Idea on the - BBQ thing.. I shortened the needle part, drilled the hole in the syringe larger to reduce the effort to push the grease out.
Worked a treat.

Magnets to pull the bushing out.. another great idea..!

Yep dry as a bone..

Modified for the job...

Carefully squirt some grease around the bearing, then push it in to the rollers.. job done.

Sounds like u squared everything away. Feels good when u get it all done and don't have to worry about it anymore.