Troubles and havent even had first ride

Blackthou said:

Hi Karl,

Been following your thread and sympathise but on the bright side as you say you've learnt loads.

I can't remember every twist and turn and know they are mainly around fuel and tps. Have you considered the plug leads as they can breakdown under load or changing out both the plugs and leads?

ATB

Click to expand...

karl rashleigh said:

hi Blackthou

i havent considered the plugs and leads at the moment, as i was hoping these were checked when it had its big service about 3 weeks ago. i am going to do the other checks first so that i can count them out and i will know where i stand when they are done. i kinda dont wont to just change them at the moment as i have brought lots of parts over the last two weeks but at the end of the day if the bike still does the same thing then i will have to trouble shoot further.

Click to expand...

Mittzy said:

Karl, You can just check them by making sure the leads are a good fit on the plugs and firm in the coils etc.

Click to expand...

Mittzy said:

Here is a pic of the TB with the little caps and injection rail fitted.

Click to expand...

Mittzy said:

Karl, You can just check them by making sure the leads are a good fit on the plugs and firm in the coils etc.

Click to expand...

karl rashleigh said:

Click to expand...

karl rashleigh said:

checked leads hoses and nipples all good, just going to start the tune shortly

Click to expand...

Mittzy said:

I assume this report is after a clean??? I wonder what they were like prior to this? Did he say what they were like prior to the test report?

Click to expand...

karl rashleigh said:

yeah they cleaned them first then tested them, so i will never know

Click to expand...