Triple K&N's install

Follow the video for Ramair, that will help you remove everything. Installing the K&Ns are pretty simple, routing the AIT sensor is wherever you want to put it to get fresh air.
On the filters I donated to the cause - the AIT filter attaches to a little bracket in one of the 2780's. Cable ties - Pah!
 
Unless you take the Mr @Claviger route. On a stock R3 Honestly I doubt the 4040's make an appreciable difference.
I went back to the graphs he posted, and didn't see any with the 4040s. As far as on a stock motor, I wound up with 167 hp with the 4040s, and Carp pipe. I didn't think the results were too shabby.
 
Thanks for this all.

Does anyone know the internal neck diameter of the replacement crankcase filter?

12mm...

Make sure you tie the air intake sensor close to the K&N's so it can measure the air temp of what is entering the filters....this is important for the tune..
 
Here's a comparison of all the filters that will fit...
upload_2018-5-12_22-59-49.png
 
Back
Top