Question about Noise while releasing clutch / Clutch Jitter / judder / Grinding noise

[Journeyman]

I replaced mine at 46,000 miles while doing the 40K service (a little late). The friction plates were still well within spec, but it appeared that the anti-judder ring had worn a groove into one of the plates. Given the time and effort to get to them I decided to go ahead and replace everything while in there. No more judder and definitely smoother shifting.

I did a video on the 20/40K service (valve check, valve adjustment, timing adjustment, clutch change and bleed, fuel and air filter, and spark plug renewal ).
The clutch replacement is at 10:08......

 

[imcool]

I replaced mine at 46,000 miles while doing the 40K service (a little late). The friction plates were still well within spec, but it appeared that the anti-judder ring had worn a groove into one of the plates. Given the time and effort to get to them I decided to go ahead and replace everything while in there. No more judder and definitely smoother shifting.

I did a video on the 20/40K service (valve check, valve adjustment, timing adjustment, clutch change and bleed, fuel and air filter, and spark plug renewal ).
The clutch replacement is at 10:08......

please can you advise, If I can just change anti judder ring as my miles on Rocket are around 18K miles,

 

[Journeyman]

please can you advise, If I can just change anti judder ring as my miles on Rocket are around 18K miles,

Unfortunately, I think it's only sold in a kit.

 

[imcool]

Unfortunately, I think it's only sold in a kit.

i can try buying hayabusa one as they are same but please can you confirm if i can get away with not changing whole clutch plates and just that one single ring?

 

[Journeyman]

i can try buying hayabusa one as they are same but please can you confirm if i can get away with not changing whole clutch plates and just that one single ring?

If all else is well, I don't see why not. Even with 18K I'd still measure the friction plates and inspect them for wear- probably fine though. Yeah, if you can match the judder ring and the plate that is grooved I would think that would do it.

 

[imcool]

If all else is well, I don't see why not. Even with 18K I'd still measure the friction plates and inspect them for wear- probably fine though. Yeah, if you can match the judder ring and the plate that is grooved I would think that would do it.

plz do you have picture of judder ring? or can you post it again or mark it from your video where is it ? so I can send it to seller and get only exact same judder ring?

thanks