NO Spark To Plugs

[Micksan]

I just got finished putting in a new/ used harness. Looked good prior to my installing it. Cleaned all connectors
Went to start it no go. Getting gas. Checked and no spark. Tune ECU shows no errors on the test mode .
Have 12.45 v to coil leads. Alfurzeses good
I am sure it is something simpthatatr it staring me in the face. Any ideas.

 

[budman]

kill switch connection?...kick stand switch connection?..ingnition switch?..

 

[Blastedbones]

Evil Gremlins haunting you.....:troll:

 

[tdragger]

ghost of Lucas.

 

[Micksan]

kill switch connection?...kick stand switch connection?..ingnition switch?..

First thanks for the interest.
The engine will turn over . So that knocks out the very obvious ( which can cause the most problems)

 

[R-III-R Turbo]

yer sure about the wiring of the coils? i think you had a thread about the colour wires for them etc didnt you

 

[Micksan]

yer sure about the wiring of the coils? i think you had a thread about the colour wires for them etc didnt you

As soon as I got a reply I went out and checked them . The green was on the right side looking fwd. All have the 12.45 volts on them.

 

[SizemattersIII]

Make sure all the leads going into the coils are clean and not corroded.

 

[Gothlander]

Check that you have connected the bank angle sensor, I think it's behind the battery.