LED turn signal problem

[Lemieuxfan]

Ha Ha Ha> that happened to me too & I think some others. All you have to do is reverse the wires on the rear indicators
Thanks DEcosse

tex and gents; where are these wires to switch located manual and can't find want to ensure i switching the correct ones.

 

[sonny]

In the process of installing back turn signals. Have one mounted and wired. After reading all this got concerned. soldering wires and using heat wrap. Real hassle if wiring is wrong. So we go out to the bike and hit the horn to insure fuse is still good. Temporally wired last light up and checked. Had zero turn signals. Really had a #hitfit, It is extremely cold outside and the thought that the wiring could be incorrect from the factory did not set well. Calming down we saw a little white box sitting on the Kitchen table. Imagine that. Installed new flasher and all is good.

 

[Lemieuxfan]

In the process of installing back turn signals. Have one mounted and wired. After reading all this got concerned. soldering wires and using heat wrap. Real hassle if wiring is wrong. So we go out to the bike and hit the horn to insure fuse is still good. Temporally wired last light up and checked. Had zero turn signals. Really had a #hitfit, It is extremely cold outside and the thought that the wiring could be incorrect from the factory did not set well. Calming down we saw a little white box sitting on the Kitchen table. Imagine that. Installed new flasher and all is good. [/QUOTE

here is my situation; replaced 3 prong relay no issue there replaced led bulbs would fire up; put originals back in work no problem. Have heard to simply switch the wires to connectors which sounds easy however there are a few wires on that ride side want to ensure i get the right ones; looked under fender in hopes of running the wire but harder than sounds..

 

[Lemieuxfan]

pleased to report i figured this out; the bulb housing undo that and those wires there-those you switch (if needed) LED's all blinking with the relay replacement much brighter/better this is a painless upgrade in hopes of making one safer.

 

[EasTexRIII]

pleased to report i figured this out; the bulb housing undo that and those wires there-those you switch (if needed) LED's all blinking with the relay replacement much brighter/better this is a painless upgrade in hopes of making one safer.

Sorry i'm late to answer. But you figured it out