George:
Couple of questions and no puns this time....
I presume that is a Clearview with the integral vent? Is that shield polycarbonate, Plexiglas or Lexan? The reason I'm asking is that I have to replace the shield on the Bonnie and I was going to get one but quite honestly, what I'm most concerned about the scratch factor. Plexiglas normally will scratch easily, polycarbonate can be hard coated whereas Lexan is naturally abrasion resistant. The stock Triumph shields are coated polycarbonate, but you can't purchase a stock shield sans hardware (thanks National Cycle), so an aftermarket shield is the only alternative. So, does it scratch easily? Was/did it mount to your hardware easily and optically, is it easy to look through?