BACK WHEEL AND BEVAL BOX AGAIN

Kevin frazier said:

Nevermind atomsplitter said better, Have to send video to u tube then you can copy it here.

Click to expand...

Steff said:

Yeah, video now sorted.

Click to expand...

Steff said:

Hi all, there seems to be a glunking sound coming from inside the bevel box when I run it in first. It seems to settle when I give it gas. There is oil in it, I checked. What are your experiences in this matter? I tried to upload a video. Apparently too big

Click to expand...

Steff said:

Try this one

Click to expand...

atomsplitter said:

That worked. I assume the wheel does not move side to side by hand. Check your universal joint.

Click to expand...

Steff said:

The wheel sounds great when I spin it. Also, no clunking spinning by hand. No side movement at all. It might be just me paranoid, first time shaft drive. Not sure what normal is.

Click to expand...

atomsplitter said:

Probably fine but the universal joint could have a bushing going out causing a 'clunk' when you initially put power to the driive shaft, which is why I suggested you also take a look there. If that checks out you're good to go.

Click to expand...