Search results for query: *

  1. Jacking up R3 Question

    There are 4 hard points on the sump that look as though they are there by design for lifting the R3 with jack, but I did hear that this may cause some damage. Any info on this subject & also on custom made mounts to work in conjunction with a jack for lifting the R3 would be great. Thx

  2. Electrical Help Request

    Thanks to all for the input.

  3. Electrical Help Request

    Planning to hard-wire a GPS, radar detector & a phone charger into my R3 Classic, each with an in-line fuse & quick detach BNC connectors. Any suggestions as to where best to tap into the electrical system? Also, would like to tap all 3 into the same location if possible. There is a zero chance...

  4. Rivco Tip Over Bars Install Question

    OK, off to the garage to get on it. Thanks !

  5. Cam Cover Leakage Question

    It is not the head gasket, it is the cam cover bolt and/or gasket that has been breached. Thx

  6. Rivco Tip Over Bars Install Question

    If the frame is staionary & upright, yes, I can use the jack for re-alignment but if the shift is horizontal or at a funny angle due to the weight leaning towards the side stand, then what? I was thinking I would use a 7/16" dia rod to drive the front engine mount bolt out repplacing it with the...

  7. Rivco Tip Over Bars Install Question

    I'm going to do an install of Rivco's tip over bars on my 08' R3 & the instructions state that the engine must be supported or lifted a small amount to take pressure off the front engine mount in order to remove the engine mount bolt. My question is, if I leave the R3 on it's side stand & jack...

  8. Cam Cover Leakage Question

    It did have a valve adjustment but I never imagined that they would use the old gasket, I will have to check the invouice to see if they billed me for a new one. Is it common to re-use this gasket?

  9. Cam Cover Leakage Question

    I have a 2007 R3 with 36,ooo miles that is just starting to show signs of moisture primarily surrounding the lead cam cover bolt & may have a cam cover gasket breech as well because there is moisture directly along that seam, (although the origin of the leak seems to be the lead bolt & the...

  10. Ignition switch failure/ headlight relay kit

    R3 Trailer How does your bike handle in turns towing that trailer loaded to capacity?

  11. Ignition switch failure/ headlight relay kit

    Beaver relay What is the primary use for this relay?
Back
Top