Recent content by Rob_The_Builder

  1. Rob_The_Builder

    M***erFing&%$$***@%#* nail in the BRAND NEW Excedra Max!

    I know nuffin and im still dumb! what gives?
  2. Rob_The_Builder

    M***erFing&%$$***@%#* nail in the BRAND NEW Excedra Max!

    :) Maybe. but what I am saying is not about the position of the bike rather its about centrifuge force. But then again we all know that the earth is flat and everything they though us as kids turn out to be fake ;).
  3. Rob_The_Builder

    M***erFing&%$$***@%#* nail in the BRAND NEW Excedra Max!

    It sounds like extrada maxes are nail magnet when new o_O. Happened to me too. plugged it once and rode it for couple thousand miles, started leaking again after very long and very hot day ride last summer so I plugged it again and put some ride-on. I always wanted to know has anyone...
  4. Rob_The_Builder

    Want to Buy DUAL ROADSTER SEAT Part # A9701140

    dm sent
  5. Rob_The_Builder

    Want to Buy DUAL ROADSTER SEAT Part # A9701140

    Looks, thats the only reason. otherwise I m perfectly happy with the standard seat that comes with.
  6. Rob_The_Builder

    Want to Buy DUAL ROADSTER SEAT Part # A9701140

    Anyone has an extra one laying around :D
  7. Rob_The_Builder

    Just a public thank you note to all knowledgeable active members and Scott specifically

    I would just like to thank everyone who keeps this community alive and maintain the website. I specially would like to thank Scott (Warp 9.9) for helping me taking my bike apart and put it back together after a transmission failure/upgrade. His knowledge about this bike’s mechanics and technical...
  8. Rob_The_Builder

    I would greatly appreciate it if you could spare 2 minutes. Sorry have to be brief (420...

    I would greatly appreciate it if you could spare 2 minutes. Sorry have to be brief (420 character restriction) Do I need to remove timing chain to remove tranny. it chewed itself out and have the engine out. Thanks
  9. Rob_The_Builder

    TuneECU -- HOW TO

    @warp9.9 and @Claviger thank you both gentlemen. The popping was not bothering me (I actually liked it) but I read here somewhere that too lean can be damaging because engine runs hotter which again, based on my non-scientific method was proven to be the case. Anyhow its running ok now (I...
  10. Rob_The_Builder

    TuneECU -- HOW TO

    @warp9.9 Thank you. That does make sense. However; would that mean that the compression will go up in the cylinder (also better performance)? Again I know you are correct based on my own experience (engine was popping on deceleration after installing exhaust mods and after a 5% adjustment...
  11. Rob_The_Builder

    TuneECU -- HOW TO

    @Claviger Thank you, That sounds consistent with what everyone says here and on other forums. I was just curious for obvious reasons.
  12. Rob_The_Builder

    TuneECU -- HOW TO

    I am sure this question has been asked and answered but the search function on the forum "lets say it is not the greatest" If you are trying to enrich the mixture, would you crank up the "F Trim" or adjust the AF table? and if the answer is to adjust the "F trim", why doing so does not change...
  13. Rob_The_Builder

    Aftermarket exhaust supertrapp setup

    Did you change your map too? apparently (and I m no expert on the issue) if you open up the tail end you could be running lean because of the easier gas flows in general.
  14. Rob_The_Builder

    Aftermarket exhaust supertrapp setup

    So with the help of mully95 I bought and installed a supertrapp exhaust on my bike. For more on that you can refer to this thread: Anyone tried XB Extremeblasters? Originally I installed it without the mid pipe and with factory TOR map and it sounded great but I think the engine was running...
  15. Rob_The_Builder

    For Sale Bits for Sale

    Hi, I want the risers. please advise how to go about payment. Thanks
See more
Back
Top