Recent content by FGR

  1. Tall Backrest

    Thank you so much for your help 👍

  2. Tall Backrest

    Thanks, that will be great.

  3. TuneEcu

    Hello Rocketeers, Any idea where can I get the Tuneecu version that allows for ABS Brake Bleeding? Your help will be appreciated. Thanks, Fady

  4. Tall Backrest

    Hello, I have a 2015 Rocket III Roadster with the standard height backrest and I’m looking to get the tall backrest. Can somebody tell from his tall backrest, the height of it from the very lower to the top edge? I want to know the difference.

  5. Headlight horizontal adjustment

    Hello Rocketeers, I’m trying to adjust the horizontal angle of the headlights. However, the botls are really stuck and not moving at all. I tried WD40 to loosen but no luck. I tried to reach the nuts holding the bolts at the bottom but they’re not reachable. Any idea on what can be done?

  6. Wisamic Led lights

    Hello Rocketeers, Anybody with experience fitting the Amazon Wisamic LED 5.75 in headlights for the 2015 Roadster? Is it a direct fit or modifications are needed? The finishing ring for example. Thanks

  7. OEM Fog lights

    I managed to disassemble it and all good. Thank you all for the advice on this.

  8. OEM Fog lights

    I tried to disassemble the fog lights by taking off the screws at the back and side but it didn’t open..

  9. OEM Fog lights

    If that’s ok with you, I can open it and send you a pic.

  10. OEM Fog lights

    Thank you, any advice on how to do it? The H3 I’m finding comes with only 1 wire with a male connector at the end.

  11. OEM Fog lights

    Hello Fellow rocketeers, Did anybody try upgrading the Roadster OEM fog lights to an LED? Any recommendations on the type of bulb (possibly H3) and what needs to be done? Thanks

  12. OEM Fog lights

    Hello Fellow rocketeers, Did anybody try upgrading the Roadster OEM fog lights to an LED? Any recommendations on the type of bulb (possibly H3) and what needs to be done? Thanks in advance

  13. 2015 RIIIR brake bleeding

    Hello Everybody, I’m currently planning on bleeding the brake for my bike (DIY). I went through the service manual for some tips and tricks. I came across this in the manual which i don’t really get so I wanted your opinion. In step 9, it’s asking me to place on end on the brake nipple and the...

  14. Ignition Question

    I meant Kill switch go on position, then turned key to on, then pressed engine start button. I usually turn key off first then kill switch

  15. Ignition Question

See more
Back
Top