Upgrades!?!

[Rockmonster]

So I finally bit the bullet and got the Dave Platt Outlaws over the lockdown. Already had the cross pipe thingy so fitting was straight forward enough except for the little bolt on the left hand side exhaust cover- what a fiddle! I need a hydraulic lift! Now I’m looking at getting the Ramair kit but it’s on back order according to the website! Gutted!i will need some help to run a different tune (when the time comes) but until then I have to sit on my finger until I can get hold of one!

 

[Stillserving]

Or just get the triple K&N setup.

 

[Ralsmith]

Ramair still available on eBay from a couple of sellers

 

[Rockmonster]

Anyone got a tune for outlaws only or isn’t it worth it? Wot do people think?

 

[Grumpy Ole Codger]

Anyone got a tune for outlaws only or isn’t it worth it? Wot do people think?

Hardly worth the effort unless you change the intake too. I have the ramair you can have but it it lacking the AIT extension wiring loom. This is available from their website for about £11.00 if IIRC... Can drop over as you're only just down the road.

 

[Rockmonster]

How come you’re not using the Ramair then GOC?

 

[Grumpy Ole Codger]

How come you’re not using the Ramair then GOC?

Changed to K&N 2780's and then sold bike 2 months later. Long sad story..

 

[Kojack1970]

Ramair still available on eBay from a couple of sellers

And cheaper! $137 USD.

 

[Idaho Red Rocket 3]

And cheaper! $137 USD.

That is where I got mine and save a few bucks off MSRP.