Greetings from CA

Does anyone have any knowledge about the coils, bearing housing, cam guides, and new bearing in the kit? Is it the same bearing as the first but I install it correctly instead? lol
I have not seemed to noticed any threads about the cam guides going bad.
 


When I was growing up just about every adult I knew worked as a mechanic/electrician out at McClennan AFB (including my mom). Somehow I ended up going into software. Ha!
 
Welcome from the upside down place , while your ripping it apart throw a Carpenter kit into it
 
Another Welcome from Auss I saw your other thread first so left my comments there
 
Welcome from about four hours south of you. I am completely lost even trying to think about how to tear an engine apart. Hopefully, I will start learning how to be my own mechanic when my boyfriend finishes finagling some drama at work. Yessssss..... Knowledge.... Btw, you have a very impressive resume there.
 
Hello Tim and welcome from VA. Best of wishes on that tear down!
 
You must log in or register to reply here.

Similar threads

Greetings from Germany!
Replies
8
Views
218
Mike188
Greetings from the Czech Republic
Replies
7
Views
137
Mike188
Greetings from Aus with an issue
2
Replies
13
Views
487
Mike188
Introduction and greetings from Singapore!
Replies
7
Views
280
Mike188
Greetings from Brazil.
Replies
7
Views
277
TURBO200R4
Menu
Log in
Register