Hello rocketeers!
I am writing my first forum post here since I haven’t seen anyone facing the same issue as me before.
I am trying to install c-bow panniers from Hapco & Becker and I have a tailtidy from evotech installed.
The problem is that the mounting bracket for the tailtidy is covering up the front fitting holes for the pannier mounts. Are there any good solution out there for this? (Other than cutting away material from the tailtidy bracket).
On evotech website they claim that panniers and bags can still be used…
Attaching a couple of pictures to try to demonstrate a bit more.
Bracket for tailtidy installed, and covering front fitting holes.
Front fitting holes for panniers shown below.
Thanks in advance!
Br,
Christian
I am writing my first forum post here since I haven’t seen anyone facing the same issue as me before.
I am trying to install c-bow panniers from Hapco & Becker and I have a tailtidy from evotech installed.
The problem is that the mounting bracket for the tailtidy is covering up the front fitting holes for the pannier mounts. Are there any good solution out there for this? (Other than cutting away material from the tailtidy bracket).
On evotech website they claim that panniers and bags can still be used…
Attaching a couple of pictures to try to demonstrate a bit more.
Bracket for tailtidy installed, and covering front fitting holes.
Front fitting holes for panniers shown below.
Thanks in advance!
Br,
Christian
