Cutting Down The Bear Claw

[Dyna494]

Hi y'all,

I'm about to cut down my bear claw to fit over some tripple K&N's and would kindly ask you to post phots of your cut down bear claws.... so I can either rip off your ideas completely or at least bastardise it. :twisted:

Seriously though, I'm sure it will help people thinking about doing the same this to get ideas especially as most rocket photos are taken from the opposite/right hand side.

 

[NativeOne]

Hi y'all,

I'm about to cut down my bear claw to fit over some tripple K&N's and would kindly ask you to post phots of your cut down bear claws.... so I can either rip off your ideas completely or at least bastardise it. :twisted:

Seriously though, I'm sure it will help people thinking about doing the same this to get ideas.

You can either cut it down or buy a carbon fibre one already cut down!



Native One

 

[Dyna494]

The carbon ones look prety cool. Esp on the black bike posted by native one. I found this on the carbon site.

 

[Dyna494]

I know this one has no claw but posted just so people can see it anyway.

 

[Dyna494]

Another one of a carbon partial claw.

 

[Dyna494]

Any one got any photos of bear claws that the have cut down themselves so I can take the dremel to mine???

 

[Dyna494]

One for the turbo Captains. Thaks to Perds.

 

[Dyna494]

Found this one too. Thanks again

 

[irieco]

I cut mine following the indentations and it still cuts into the third filter.

Of course I was drinking at the time.

FYI - The indentations don't quite line up with the filters.

I used a dremmel (not recommended...took forever)

When I take mine off to repaint it, I'm just going to follow the upper curve.


L.C.

PM sent

 

[tazoom]

Anybody have a website for the carbon fiber claws??