albertaduke
former airline pilot without the big bucks
after a lot of checking and looking I built a very inexpensive lift table with plywood steel tubes (gas line) and lumber the whole thing $65 in supply I use the floorjack in the front and a small jack in the back due to the fact my floor is not flat .
I never though about checking the floor surface it does create problems but since I use the table once a month it is no big deal.
picture shows the lift at the low position about 10 inches of the ground ,the max is 19 inches above the ground
the blueprint are available on ebay for $17.
I would do a few things different considering the weight of the bike . I will modify a few things , front wheel clamp, latches, and width. beats the $1200 for a good table capable of handling the rocket
I never though about checking the floor surface it does create problems but since I use the table once a month it is no big deal.
picture shows the lift at the low position about 10 inches of the ground ,the max is 19 inches above the ground
the blueprint are available on ebay for $17.
I would do a few things different considering the weight of the bike . I will modify a few things , front wheel clamp, latches, and width. beats the $1200 for a good table capable of handling the rocket