Recent content by imcool

  1. Looking for tyres in Australia

    if you drive normallly then go for it but if you drive rocket like sharp turns, high speeds turns, then I would not suggest bridgestone for front, front must be either cruisetec or cobra. bridgestone rubber is bit on stiff/harder side as compare to cobra hence grip could be an issue. I am...

  2. What mode?

    check the mods in my signature if you want to go fast on this bike

  3. Brake and clutch fluid gets dirty fast

    already discussed several times, @Journeyman said its because clutch get used more thats what causing it if your brake is getting bad as well that means you need to change brands, but clutch is getting bad fast enough for everyone regardless of brand

  4. Display, any one know how to take this apart, pin broke on back second one after less then 200 miles dont want to spend another 1,500 USD.

    there is a video here, you can some lead from it. looks like an easy repair since we have part available now to fix it. https://www.aliexpress.com/item/1005009466430560.html

  5. Anyone Else Lost a Heat Shield Yet?

    the issue is cheap nuts and weld on it, it tends to slip the thread/rip the thread. of nut, though torquing will help but dont rely on it as permanent solution.

  6. Triumph dealer scan before 2 yr warranty ends

    I second that, its the best thing ever if you have triumph.

  7. Triumph dealer scan before 2 yr warranty ends

    its OEM dealer tool which connects to triumph servers from dealership. but that paper is good for nothing because soon as you walk out of dealership it will be useless as for next time, for instance- next service, bike selling, you will have to get another scan.

  8. Need help with removing throttle housing on handlebar

    I made that "plastic tool' with a flat head screw driver 2mm thick or a 2mm thick steel iron rod

  9. Rocket 3 R storm seat fouling on negative battery terminal

    thankyou for bringing this up

  10. Rocket 3 R storm seat fouling on negative battery terminal

    I take my words back, its not good to have terminal installed like that, STUPID F*** DEALERS !!!!!!!!!!!!!!!!!!!!!!. I need to move my negative terminal to side ways now as there is plastic damage on the seat tab over these years because of terminal,

  11. Need help with removing throttle housing on handlebar

    OP did not need to open those yellow screws for handlebar removal. you dont need to unscrew them. only need to remove the philips, I added my photo below in red circle if ever somehow you feel the need to remove the yellow ones you need one of the bits below.

  12. clicking/ticking noise once bike is hot

    I just tightened the exhaust header bolts, they were off by 5Nm (4lb/.ft) . not sure how because I remember torquing them up last time to manual specs. Will go for ride and check later for any improvement.

  13. clicking/ticking noise once bike is hot

    oh, i definitely didnt do that, retorquing after riding. thanks i will do that and go for ride and update you later.

  14. Need help with removing throttle housing on handlebar

    hi. its easy, you need to get a tool to I have put TFC handlebar on 3R but later sold it because I had no risers to accommodate the longer brake lines. if you are replacing handlebar, then you need to disconnect the connection from below the front screen. can you show more pictures where you...

  15. clicking/ticking noise once bike is hot

    thanks for clue, I will check the headers, i did open them 6 months ago, i will check their torque
See more
Back
Top