Search results for query: *

  • Users: dd14x
  • Order by date

  1. Heat Shielding Experiment

    Lived in MN for 6 years - couldn't ride in the winters :)

  2. Heat Shielding Experiment

    Following this thread after riding today.... had no issues with my Storm GT since I got it last September. Rode to work today early morning - no issues. But on the way, back, got out only at 2pm, weather was warm/hot (~90F). And at every red light, I struggled to keep my right foot from getting...

  3. Horn Installation: Denali Soundbomb Compact / Denali Soundbomb Split

    thank you - that still looks like the soundbomb mini. I was trying to see if the soundbomb split could be attached.

  4. Horn Installation: Denali Soundbomb Compact / Denali Soundbomb Split

    thank you - that's for the soundbomb mini - I was trying to see if op managed to get the soundbomb split installed.

  5. Horn Installation: Denali Soundbomb Compact / Denali Soundbomb Split

    Bump - were you able to install it? Any guidance - I have not purchased either yet - would like the split one but couldn't find any place to mount the compressor (not sure if the horn would fit in the stock location either - looks like it is a half inch wider than the split one)

  6. Any quickshifter tips??

    Yep - dealership did the install, and it is enabled in the menu. To confirm, when attempting to upshift, stay on the throttle while upshifting. Before downshifting, roll off the throttle. If that is right, I will take it back to the dealership this weekend.

  7. Any quickshifter tips??

    for the folks that have the Triumph QS installed - I could use some guidance. Got the QS installed. About half the time, it works as expected. But the rest of the time, I can't seem to get it to shift up or down (I don't use it from N to 1, or 1 to 2 - or the other way around). The lever just...

  8. Additional Aux plug fitted today

    https://www.r3owners.net/threads/left-side-aux-power-socket.53847/page-2#post-828204 This is how I installed the boot (didn't have the pliers you referenced)

  9. Evotech LED Scrolling Signals

    Thank you both! I will give it one more shot this week - else I'll have to go to the dealership - worried I'll strip those

  10. ODB port 2020 Rocket 3

    My bad for resurrecting an old post - I was just trying to locate the OBD port under the seat - only see the large 20 pin port and have not seen that type on other motorcycles I've had - usually a 6 pin port

  11. Cleaning metal parts?

    I applied a ceramic coat to the aluminum bits when I coated the rocket. Didn't think of lacquer - will have to give it some thought :)

  12. Rear turn indicator loose

    Nah - the splash guard was easy to get to since the screws face towards the back (not towards the wheel)

  13. Rear turn indicator loose

    You are right - that would definitely make it easier. Not sure I feel confident enough to try that (esp with travel tomorrow). Will try to muster up some courage next weekend :)

  14. Evotech LED Scrolling Signals

    What size are those 2? I can't get any size to fit there

  15. Rear turn indicator loose

    I cant figure out how to remove the top cover... There are 2 hex heads behind the reflector (facing the tire) - supposedly M5 - but I don't think they are - m5 is too large and I can't seem to get any to fit... Ugh

  16. Rear turn indicator loose

    Ok - so there is a nut inside the plastic that is holding that screw in?

  17. Evotech LED Scrolling Signals

    So, um, how do you remove the rear indicators? Mine is loose and I can't tighten or loosen it https://www.r3owners.net/threads/rear-turn-indicator-loose.54931/

  18. Rear turn indicator loose

    Thank you - I've been trying to loosen that, but it just keeps spinning in place - is there a nut within the plastic?

  19. Rear turn indicator loose

    Not sure when, but somehow, my rear left turn indicator (2025 storm GT) is loose. Guessing somebody bumped into it at the parking garage - no visible cracks/scratches. I tried to tighten the 5mm Allen screw, but it just seems to spin without doing anything. Any guidance on how to realign and...

  20. ODB port 2020 Rocket 3

    Is it the 16 pin OBD2?
Back
Top