Search results for query: *

  1. mm-dmoney

    Neutral issue - Gear position sensor (GPS)

    Well, I'm back with this issue as the cleaning described above only lasted about 9-10 months before having issues again. :mad: Cleaning the sensor with the port I drilled didn't do the trick, so this time so I used a Dremel disc blade to cut off the washer holding the GPS sensor together to get...
  2. mm-dmoney

    Where does this go?

    I just checked the motor over and couldn't find anything obvious. However, I remembered that i took my saddle bags off recently and those have rubber plugs for the spare mounting locations. That's where it goes! Solved!
  3. mm-dmoney

    Where does this go?

    It's smaller. Less than 1/2 inch...
  4. mm-dmoney

    Where does this go?

    Im pretty sure this is from my 2011 R3R. Any ideas where it goes?
  5. mm-dmoney

    Neutral issue - Gear position sensor (GPS)

    Thanks all, I got it cleaned and working again! Here's what I did: Carefully drilled area out that had the recessed #3 mold marking with a ~9/64" (3.5mm) drill bit. I was really careful to not damage the sensor contact pads when the drill bit broke through to the sensor's inside. I cleaned the...
  6. mm-dmoney

    Neutral issue - Gear position sensor (GPS)

    Thank you both for the helpful information. Now that I see the insides of the sensor, I might try to clean it first without disassembly. If that doesn't work, I may try to dremel the washer off to clean. One question for oteczdmitriy, what did you use to reassemble after cleaning, a...
  7. mm-dmoney

    Neutral issue - Gear position sensor (GPS)

    Hi all, I've recently had an issue where my GPS will no longer detect Neutral. I removed it from the housing and am able to rotate the sensor to various gear positions, but it just jumps from 1st gear to 2nd gear without sensing Neutral. Some other forum posts talk about removing the pin (and...
Back
Top