Recent content by THECRAIGMEISTER

  1. Paint Can Rattle

    I guess as long as the noise was only the secondaries I am not so worried about it anymore. It is gone now but I think I will just remove my O2 sensor and put back in the 20050_3 tune and have the full power in all gears so my bike will run like it is supposed too. I am happy with the...

  2. Paint Can Rattle

    I got my bike back and it has finally cleared up enough to put a few miles on the bike. I rode for about 20 miles a few nights ago till I was too cold to ride anymore. It was a balmy 38 degrees. Anyway with the new Triumph tune the bike doesn't seem to run bad just not as good of throttle...

  3. Paint Can Rattle

    So the bulletin is just for idle? Doesn't have anything to do with the secondaries? I wonder how they got the noise to go away? What on the lower sprocket would cause this noise? Does the sprocket become loose or something? I have read all the threads on this and I am still confused as to...

  4. Paint Can Rattle

    I took my 05' Rocket with 1400 miles to my nearest dealer 5 hours away to check out the "Paint Can Rattle" noise it has made since I bought it last summer with 400 miles on it. I was informed today that the dealer performed a "service bulletin" on it to synchronize the secondaries in the...

  5. Tuneboy help.....Won't start?

    Apparently the plugs were fouled? When I took a few out they were a little wet but I didn't think it would cause it not too fire at all in any cylinder? I guess when I installed my Throttlemeister a few days before i played with the throttle too much adjusting the meister? Funny thing is that I...

  6. Tuneboy help.....Won't start?

    I removed the eliminator. Put the O2 sensor back in pulled plugs and checked for spark and fuel. Double, triple and quadruple checked the tunes, I was told on the phone that the noise might be the timing chain tensioner. I am not so sure it didn't skip a tooth or several and throw the timing...

  7. Tuneboy help.....Won't start?

    I updated the software in my laptop for tuneboy. Loaded the correct tune and unchecked and removed the O2 sensor. It started up afterwards but the check engine light was on. I today installed the DynoJet O2 sensor eliminator and tried to start it to load it up and haul it 5 hours to Denver CO...

  8. O2 Sensor

    Great. I will give it a try. I didn't know that tuneboy diagnostics would show what error code was in the computer for a check engine light. Thanks for the info.....Craig

  9. O2 Sensor

    Freightbusters......Yes I noticed a SOP difference and as posted here there is proven dyno increases because of the full power in all gears instead of 4th and 5th due to secondaries staying partially closed in factory tunes plus correcting the speedo error of 7% plus the unlimited "tuneability"...

  10. O2 Sensor

    I unchecked the box and loaded the 20050_3 tune. I completely removed the O2 sensor prior to loading the new tune and when I started my bike it had the check engine light on? Should it not come on if I unchecked the box when I loaded the new tune? If not maybe I should unhook the battery and...

  11. O2 Sensor

    I am assuming that without the O2 sensor hooked up it is causing the check engine light to come on? I figured if Pig9r used it then I probably needed it. I haven't received the O2 eliminator yet but my check engine light is on? Don't know what else could cause it besides the O2 sensor since...

  12. O2 Sensor

    Pulled the O2 out and plugged it with a M18 oil drain plug, removed the wire and taped off the connector to keep dirt and stuff out until my O2 eliminator from Dynajet comes in. Really was pretty easy. I had one bolt in my heat shield by the O2 sensor that was seized but I dremel tooled and slot...

  13. O2 Sensor

    Ok, I will unplug it and remove it. I don't see why I would ever need to hook it back up but I imagine it might be fairly expensive to replace it? Jack, on the noise I talked to Foothills last fall and they want me to bring the bike in. I am probably going to load it up as soon as I can take a...

  14. O2 Sensor

    I am getting ready to dig my Rocket out as the snow is starting to melt here in Wyoming. I am going to download the latest Tuneboy software update and the latest tune. I have TOR's, Cat Bypass and the Triple Uni Filters. I Did not unhook the O2 Sensor or uncheck it in the tune. Can I when I load...

  15. avon cobra tyres

    It is a different bike but I put 3 sets of Metz's on my VTX1800. It was modified and put out some power. I was really not happy with the tire life of the Metz's. I tried the Avon VenomR and it was a much better tire. Where I would spin with the Metz I would stick with my Avon and lift the front...
See more
Back
Top