Recent content by Patto

  1. Patto

    Front calliper torque settings

    It a lot easier to split them and the rebuild kit comes with new seals for were they join together
  2. Patto

    Hot front brakes

    Will give that a try tonight thanks
  3. Patto

    Hot front brakes

    When pulling the brake And releasing the wheel will spin again , it rotates about 1 Wheel revolution , on a side note since bleeding the brakes when The lever is first pulled it fells soft then if you pull it a couple of times it will harden up , is there a technique to the rocket or do I need...
  4. Patto

    Hot front brakes

    The disks are newish ebc ones
  5. Patto

    Hot front brakes

    Got the front raised and wheel spins but pads are Rubbing against the disk all the time , I thought the pads came back a mm then nipped up again once you brake ?
  6. Patto

    Hot front brakes

    Hi everyone I have a problem and looking for ideas why , the front brakes disks are too hot to touch the right hand side disk even more after a short ride and gentle braking to a stop . I tought I had a sticking calliper so got a rebuild kit and fitted new seals and pistons to both callipers ...
  7. Patto

    Front calliper torque settings

    Thank you for the info , will rebuild the calliper once the kit arrives
  8. Patto

    Front calliper torque settings

    Hi all my front rh caliper seems to be dragging , have checked the pistons and One has rust spots on it so have ordered a piston and seal kit off eBay , I was going to split the calliper to rebuild it but can’t find the torque settings for the 4 bolts that hold the calliper together , any clues...
  9. Patto

    Hello from north east UK

    Will have to get down for one of them work permitting
  10. Patto

    Dyno Tuner in the north east

    Carl is recommended as well as Bsd tuning but both a long round trip if I don’t find anything near by will have a ride down
  11. Patto

    Hi From England.

    Hello from up north
  12. Patto

    Dyno Tuner in the north east

    Hi , i have tune ecu on my laptop and a cable that seems to work ok , bsd looks good but a 6 hour round trip plus how long they take to tune it
  13. Patto

    Dyno Tuner in the north east

    Hi I am trying to find some one to tune my bike after fitting a ram air filter , the bike has Dave platt outlaw exhaust already fitted . I will try to load a tune ecu map to get it the ball park for settings but would like to have it fine tuned I am in the north east uk near Durham , I have...
  14. Patto

    Ram air and Dave platt outlaw exhaust fitted needs tuning

    Thanks for the info will load the tune then book a dyno set up
  15. Patto

    Ram air and Dave platt outlaw exhaust fitted needs tuning

    Hi all i am after some guidance please , I have a 2016 roadster which has Dave platt outlaw exhausts all ready fitted , I am going to fit a ram air filter and would like to tune it is there a good tune I can upload using tune ecu or is it best to take it to a dyno shop ? , Just rockets at...
Back
Top