Recent content by markc

  1. markc

    Coolant type for -09 Classic (IAT/HOAT)

    I have an 07 classic and have always used what u call the green stuff. No problem with it. Make sure u bleed the system per the manual when changing the coolant.
  2. markc

    Engine end driveshaft lube?

    You have to use a moly type grease. Honda moly was the best. I believe 60% moly. The splines on the bevel box end of the shaft will wear very quickly if a moly lube is not used. Markc
  3. markc

    Progressive rear shocks

    Why does the 13 inch length give a better ride?
  4. markc

    Progressive rear shocks

  5. markc

    Rear brake rotor replacement

    Where did u get ur bolts from?
  6. markc

    Decided to get a r3 touring

    The vibration you feel is around 3200 rpms and it goes away if u pull in the clutch in alittle?
  7. markc

    For Sale 2014 R3T Parts

    I sent you a couple of private messages. Markc
  8. markc

    Lubing the shaft

    I believe 1k9 is correct. That end of the shaft doesn't slide like the end at the rear end. Bevel box.
  9. markc

    Tail light bulb

    What is the bulb number that I need to use to replace the tail light bulb in my 07 classic? Thanks MarkC
  10. markc

    Tail light bulb for a 07 classic

    What is the replacement bulb that I need for the rear tail/brake light bulb for a 07 classic. A Koito bulb (Japan) is the OEM bulb. I read where the 1157 draws more watts than the 7528. Thanks Markc
  11. markc

    Electrical Gremlins Part 5: The Reckoning?

    I agree with turbo200r4. Looks like your battery is weak. should have a minimum of 12.4 volts.
  12. markc

    Speedometer Repair

    did they install a new board? If so, did you get your old borad back. Most boards have a part no. or other details on them. One might be able to source the board online.
  13. markc

    Where would be the best place to get tires

    Where do you live? Rocky Mountain ATV Motorsports is where I buy mine. I live in Ohio and one of their two warehouses is in Kentucky. I get my orders overnite. They have good prices also. MarkC
  14. markc

    Driveshaft/rear axle maintenance

    Dr Drain plug only needs to be torqued at no more than 5 or 6 nm. The center of the plug is hollow . It has magnetic material in the end of it. Be careful when you are tightening it. Will break very easily. I use a 1/4 in drive ratchet to replace the plug. Be careful.
  15. markc

    THE REBIRTH OF NUMBER 74

    Sonny, I replied awhile back ( maybe 3 or 4 weeks ago) that I used what Triumph uses in the factory when they build the engine for the rocket Threebond 1207B. You can find it on amazon for $17.00 or $18.00 a tube. You will use most of the tube to seal the two halves of the engine cases back...
See more
Back
Top