Recent content by ken

  1. ken

    Leaky Coolant Pump has me bummed out....

    I have stripped down lots of water pumps on a number of rockets. I always use quality sealant on top of the o ring to hold it in place and increase the seal to stop any leaking
  2. ken

    Clock on '08 Classic losing time: help ?

    you could be right but it is an 08
  3. ken

    Clock on '08 Classic losing time: help ?

    what a good answer it makes sense as it is 12 years old thank you
  4. ken

    Clock on '08 Classic losing time: help ?

    that's my thinking at the moment I will have a look shortly
  5. ken

    Clock on '08 Classic losing time: help ?

    Hi all the clock on my classic has suddenly started to loose 1 min in every 5 min . I don't know if the bike is just depressed in lockdown or there is a simple answer to the problem
  6. ken

    UK

    I am
  7. ken

    rev counter stopped working

    My rev counter is not sweeping, when the ignition is switched on the idiot lights flash for half a second and that is all it does , also the time clock has stopped working. All backlighting works and when I plugged tune ecu in all is fine but not showing on rev counter. I have swapped out fuses...
  8. ken

    Installing An 18" Air Horn...'Cause Bigger Is Better!

    Fitted the 18inch air horn with a relay works perfect, my question is if I wire it with the original horn still working the horn operates when the ignition is off and I use the brake front or rear . Ignition on and all works perfect. I am thinking of leaving it as it is to deter thieves as they...
  9. ken

    New farkle for my R3T

    want one were can I get it
  10. ken

    Photo shoot

    thank you took a little while to do
  11. ken

    Photo shoot

    Its not as clean as it looks but not bad for 74000 miles so far
  12. ken

    Photo shoot

    I was invited to a photo shoot with a load of Harley guys. talk about a rose between thorns.
  13. ken

    need of a set of front wheel bearings

    thanks all for your help I have gone for ntn bearing made in japan I will see how they last. the oem ones lasted 70,000 miles
  14. ken

    need of a set of front wheel bearings

    Could anyone point me in the direction of the best wheel bearing manufacturer thanks in advance
  15. ken

    New Avon Cobra Chrome - any good

    Fitted one on the back 2 weeks ago, instantly noticed a difference straight away, I had to get used to how it just dropped in to a bend and made the bike feel a lot lighter and so smooth as well. It cost £170 so about the same as the old cobra's I fitted
Back
Top