Recent content by BeastMaster

  1. BeastMaster

    Help! Poor running and I want to go to Sturgis

    So you had exactly the same problem I did!!! Even down to the back fire. Thanks for letting me know. I plan to try and put an o-ring on that shaft and packing the area full of dielectric grease. Then periodic inspections I'll let you know how it goes Gregger. Suspect the unburnt fuel evaporates...
  2. BeastMaster

    Help! Poor running and I want to go to Sturgis

    I finally had some time to dig in to this TPS sensor and figure out why it failed. The reason became evident pretty quick when I started grinding the plastic housing away. I found It was full of fuel. I wish I had some clue just how it got in there. Maybe bad tuning from my random map trying...
  3. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Tuneecu updated last nigh and everything seams to work perfectly. Lesson learned to anyone rocket TPS sensors are junk, be sure to have a few around.
  4. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Apologies for not responding phar2slo, it's been a crazy month. So I think it turned out to be the TPS sensor. It would randomly freak out under heat vibration idk. Basically it would cause it to run crazy rich and die or not idle at all. I couldn't catch it in the act, until I got my bike...
  5. BeastMaster

    Help! Poor running and I want to go to Sturgis

    There is definitely a glitch on the tamzu lol.
  6. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Okay the saga continues I got the bike back this morning. It is ridable somewhat when defined loosely. The shop told me I somehow had two maps and that were fighting each other. The problem is they loaded what I think is a stock map. So at cruise throttle rpms it lean surges and sometimes cough...
  7. BeastMaster

    Help! Poor running and I want to go to Sturgis

    I really think that's a possibility. Sadly I have limited tool part ect. Hopefully the shop will have something tomorrow 🤞
  8. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Thanks turbo for some reason I I tried disconnecting the servo and the bike didn't start. As In the starter seemed disabled. It's at the dealer now. Hopefully they can figure it out 🤞.
  9. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Okay that's exactly what I thought. Unortunately that really makes it worse/better. I've done all of that with no good reaction. I can see the black smoke coming from the exhaust. I seriously can't thank you enough. This is one of the worst kind of trouble shooting problems heat soak issue...
  10. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Yeah that's what I was thinking but above 2000 RPM's it runs just fine. That sounds exactly it right now. But the only problem is the primary idle stop does nothing!!! I've adjusted it in both directions and back. It doesn't help. It will run good then crappy. I have ram air and a paul Brant...
  11. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Yeah the problem is it's always hot lol. The coils looked pretty good this morning. It will run good a few stops and the it will try and die. I can smell it's rich/unburt fuel.
  12. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Okay new update sadly the bike did great all the way to Denver. When I went to leave Denver for Sturgis it acted up again. I have to hold idle now just to keep it running. I have done an ISCV rest a few times now here I Sturgis. It seams to get weird when it's hot. Cruising "seems" okay just...
  13. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Found the problem. But along the way, I have the honey Badger running at it's best now. The front number 1 plug wire came loose. I must have pushed on those 10 times but this wire was stubborn! Lesson learned lol. Thanks for all your help again guys.
  14. BeastMaster

    Help! Poor running and I want to go to Sturgis

    Okay so new update I apologise for not getting you guys the best information. In the last tune modification, I changed the fan to turn on at 100c, instead of 94c. Not realizing it would be that sensitive. I couldn't imagine it being the problem, at that time. But as I thought through the...
  15. BeastMaster

    Help! Poor running and I want to go to Sturgis

    So an update I really cleaned and lubed everything well. Did the ISCV full reset and 12 min tune. It will run good for a bit but I still get stumbling in curtain conditions. If I Rev right threw that area everything is fine but if I let linger it's bad. I'm going to lift the table an check...
See more
Back
Top