Front tire problem, HELP!

I appreciate all the info and jokes guys. So am i to believe that there is no rhyme or reason for my front tire to be doing this?
 
If you were in Australia I would say that is completely normal as these bikes ride with a slight lean to off set the camber on the road. Thought in the US it would be your left side which would wear quicker.

Yep, I had the same problem.
Over the years I'd look at my front tyre and see that it was always worn way more on the R/H side.
Eventually I learnt that this was due to the camber of the road so consciously pushed harder into L/H corners to balance this up
This worked well as I slide better out of L/H corners than R/H
 
I appreciate all the info and jokes guys. So am i to believe that there is no rhyme or reason for my front tire to be doing this?


is the back tire wearing the same?
If it's front tire only, you may try lifting the front off of the ground & then lower until tire is just touching with bars straight - loosen your axle, then loosen the yokes that the forks are clamped in (top & bottom) - Then re-torque the axle - then re-torque the fork yokes (and make sure the fork tubes didn't slide up in the yokes - make note of where they are before loosening yokes)
I don't know if the forks not being aligned straight would cause that wear or not, but at least you would know the forks are now aligned straight
 
I appreciate all the info and jokes guys. So am i to believe that there is no rhyme or reason for my front tire to be doing this?
dont know much myself but will have to lean warps way crash bars?may need to torqued to specs again?