pacificblue
.020 Over
Hello all , good a friend says he is getting a cloncking from drive shaft on gear change ,any ideas please ,done 14500 ,o5 plate 2005 -6 terry.
clonck fromshaft
- Thread starter pacificblue
- Start date
Boog
Traveling Story Teller
- Joined
- Oct 17, 2013
- Messages
- 8,501
- Location
- Dumfries, Virginia
- Ride
- 2014 R3T, RAMAIR, Full Viking Dual exhaust
Hello Pacific Blue, hopefully it just needs more molly applied. I would not think on that low of miles it would be worn out at any point along the drive train.
Do you know if the bike has ever been under water or at least up to the axel? If water has crept in anywhere, it will wear out quickly. Normal rain riding should not do that though hence my wondering if it has went swimming during its tenure on earth.
Do you know if the bike has ever been under water or at least up to the axel? If water has crept in anywhere, it will wear out quickly. Normal rain riding should not do that though hence my wondering if it has went swimming during its tenure on earth.
warp9.9
Pocałuj mnie w dupę
Can he tell which end of the shaft?