Search results for query: *

  1. r3badboy

    Rocket III Roadster tank swap and other mods

    Mate sent me the photo's (actually his wife as he doesn't use a phone 😂) but I know he cut the bottom off the rocket tank & welded it onto the victory.
  2. r3badboy

    Rocket III Roadster tank swap and other mods

    Here ya go...🚀
  3. r3badboy

    Rocket III Roadster tank swap and other mods

    A mate of mine used a Victory tank, haven't caught up in a while but will take pics when I do 🚀
  4. r3badboy

    Clutch switch alternatives

    Yes good move, I did have problems with old gps, some which you described but mine was more running rich & fowling plugs.
  5. r3badboy

    Clutch switch alternatives

    So you have an early Roadster 10-14 ? I have had problems with the stepper motor on a 10 roaster. Tried a new one, no difference after setting with tuneecu, all values correct etc. Ended up putting stepper motor in airbox under seat (needs to be left plugged in) & set idle screw around 1000 rmp...
  6. r3badboy

    Clutch switch alternatives

    Yes exactly, over 20 years & 6 rockets haven't had one fail, they only need a good clean here & there. I give them a good clean with electrical cleaner & then lube with silicone spray 🚀
  7. r3badboy

    Clutch switch alternatives

    What year is the bike? I can't remember but isn't the wiring for the clutch switch part of the main loom 🤔 The switch looks very similar so if anything you could splice it into the original wiring.
  8. r3badboy

    Rocket 3 backfireing

    You have primary & secondary butterflies in your throttle bodies. The secondary ones are the outer ones.
  9. r3badboy

    Rocket 3 backfireing

    Ok, i can send you a tune to your email you can try, from memory o2 sensor is off, but if it isn't untick it & save map again. Is your second throttle at 100% or have you removed second butterflies?
  10. r3badboy

    Rocket 3 backfireing

    Be more specific, do you have underseat air cleaner or k&n or ramair?? What make is the slip on muffler? I may have a tune for you depending on your exact setup?
  11. r3badboy

    Feeling achieved

    Depending how your cutting your bear claw, you might want to stick your ait sensor as in photo 🤔
  12. r3badboy

    Water pump hoses

    You can buy a setup that plugs into your obd2 plug that will read temp & also does speedo & volts
  13. r3badboy

    Rocket 3 Roadster 1st Gen 2004-2009 & 2nd Gen PARTS 2010-2019 !?!

    Me too, but that's why I have 5 of them ...just in case 😅🚀
  14. r3badboy

    TuneECU wanted de-cat mod pipes 3 k&n

    You can always copy & paste a tune that's not compatible but has same setup your bike is running. I have done this on a couple of mine. Copy map values from a map you like, open your original map & paste. Save map. Check devices & untick or tick what you want. Save again & then download to ecu.
  15. r3badboy

    K&N filter fitment

    Aliexpress bottle, welded 2x mounts that fit onto original radiator cowling mounts.
  16. r3badboy

    Inherited a 2018 Roadster

    Yes, got the 9 inch grinder out 😅 Oooops that was another for ramair, I used a dremel for the red one 👍
  17. r3badboy

    Inherited a 2018 Roadster

    Or more subtle...🚀
  18. r3badboy

    R3 classic running like a twin. Backfiring and stumbling

    Have you checked fuel pump pressure? Might need a new fuel filter...
  19. r3badboy

    R3 classic running like a twin. Backfiring and stumbling

    Sounds like a crook injector. If its that it won't show up a fault code. Best way is to buy a cheap injector cleaner kit & test all three. If it doesn't open & spray that will be your problem. Had it happen to me & just bought a second hand one from the wreckers. Cold to the touch on one of the...
  20. r3badboy

    R3 classic running like a twin. Backfiring and stumbling

Back
Top