Recent content by roame

  1. roame

    Seat latch issue

    I had the problem shown in the previous post where the cable had come out of its holder. I managed to get my fingers under the seat and snagged the cable and pulled. The seat released.
  2. roame

    Corbin Products

    I bought a Memphis Shades Spoiler windshield for 96-13 FHTC / FLHTC / FLHTCU / FLHTK / FLHX / FL TRIKES. I got a dark smoke 9.5" tall. It has lifted the air up pretty well. Corbin does mention what HD model shields will fit their fairing, in their literature.
  3. roame

    Corbin Products

    I'm not aware of any dash board being available. I think you would have to relocate the ignition switch if you were to block off the void area. I've seen some good pictures on this forum, which helped me decide to get one. I used to know how to look at picture galleries on here, but that was...
  4. roame

    Corbin Products

    I ordered a seat from them in October and got it in about 3 weeks. I ordered a fairing in October also, it arrived January 31. My only complaint is that I called in December and they told me it should ship in about a week, I called again a couple of weeks ago and they told me the same thing...
  5. roame

    lower performance in gears

    any chance your clutch is slipping?
  6. roame

    Oil change end season vs start season?

    Sulphur compounds are deposited in engine oil due to the combustion process. There is always some leakage from the cylinder around the rings. When these compounds mix with water that has condensed in your oil it creates an acid. If you've ever seen black stains on bearing surfaces you've seen...
  7. roame

    general common breakdown/breakin issues question

    no problems, almost 2005 24kmiles, one front tube oil seal leak. I did have clutch shift problems, but found there was no bushing in my lever. 10mm hole, 3mm pin. Made it hard to keep the clutch adjustment correct. I put a bushing in and that cleared right up. I had to wonder about that as...
  8. roame

    R3 Speedometer is off

    tuneboy You need to reset your wheel speed constant to correct your speedometer. If you change tire sizes you may need to do it also. I went to a car tire and had to reset mine, I use a tuneboy. I think I just did a ratio of the tire circumference to the wheel speed constant. standard...
  9. roame

    Question about 05 Rocket TuneECU and D&D pipes

    same setup I'm running an 05 with D&D pipes, cat removed and running the 20226 tune. Runs good, and there is some decel popping but on those days that it's bad I just pull in the clutch. On the edit situation. Apparently the speedometer set is low by 6% I believe, so your not traveling...
  10. roame

    front axle

    i use a 9/16 coupling nut. I couldn't find a 19mm hex wrench, went to homedepot and got the coupling nut for a couple of dollars.
  11. roame

    Liscense plate redo!!!!!!!!! higher mounted

    led lights You can put a load resistor 6ohm 25 watt across the signal light and the original flasher unit will work normally. The resistor mimics the light bulb load so the flasher blinks at a normal rate. you need the large wattage rating so it can handle, dissipate, the heat that is...
  12. roame

    speed limiter

    I'm running vr rated tire and see the speed limiter set at 135. No problem to change but I'd like to know how the speed is limited. Is the ecu reading the speed input signal and cutting back the secondaries? Are there any other(motorcycle equipment) considerations than tire quality to limit...
  13. roame

    same old question, what tune.

    Thank Ya'll. i'll fix up a tune and see how it goes.
  14. roame

    same old question, what tune.

    I appreciate it. I did the speed correction and left everything else alone. Secondaries are at 100%. When I pull the plugs I'll decide if I need to run a leaner mix. I had noticed some soot at the tailpipes with stock pipes and I'd have to take it out to empty road to clear it out on...
  15. roame

    same old question, what tune.

    No when I asked it to retrieve the ECU number it came back with 020050. I was wondering if I should load 20222 since I'm running a stock air filter.
See more
Back
Top