Recent content by JaR3d85

  1. JaR3d85

    Rear wheel bearing, has this been solved?

    I was thinking something along those lines with there being a possible shift over time causing these to fail over time? I wonder if there is a correlation between specific years? My roadster is a 2014, like maybe a factor tolerance was changed or revised? I dunno, I also said screw is and...
  2. JaR3d85

    Rear wheel bearing, has this been solved?

    I greatly appreciate the long post! This thing is driving me insane, i have read through a ton of posts on here in regards to the rear wheel bearings any and all information I can get and compile would greatly up my chances to hopefully figure out the root cause of this happening...
  3. JaR3d85

    Rear wheel bearing, has this been solved?

    I did not measure the spacer, your talking about the 177.97mm right? It did have a little marring and what I would call stamping looks like from a misalignment when bearings were installed like half circle stamps from the bearing being installed with the spacer off a little, it could have been...
  4. JaR3d85

    Rear wheel bearing, has this been solved?

    I don't want to do this and bring it up but I just replaced my rear wheel bearings 4k ago and last night had to replace them again and after a 30 mile ride today when I roll the bike back and forward it clicks multiple times before full wheel revolution either way... I'm really not happy about...
  5. JaR3d85

    2014 roadster Intake backfire on rev match

    Ramair intake with a Dave platt single 16 inch. I hooked my smoke machine up to it and there was no significant leaks I say significant because there wS only 1 spot on the middle intake port where the rubber sleeves that cover the rods that connect all the butterfly's together but I sealed it up...
  6. JaR3d85

    2014 roadster Intake backfire on rev match

    I wish 😂, it only pops 1 one time when it happens and sometimes it's loud other time not too loud but noticable, intake doesn't pop otherwise. I wonder if an actual dyno tune would fix it?
  7. JaR3d85

    2014 roadster Intake backfire on rev match

    Just wondering if anyone else has had or currently experiences an intake backfire when the rev match to downshift there first gen? It it only 1 pop when I blip the throttle downshifting from usually 3rd gear and down the high gears it doesn't usually happen.
  8. JaR3d85

    Wanting confirmation... Rear wheel ticking...

    😂 What gets me is as soon as you told me that it needs hp222 I called that thing 😂 I called it out after you told me it needs greased, I told it I cannot trust it any longer ... Lol I did have pretty good luck with it though with painting my crash bars... They did turn out pretty good thanks to...
  9. JaR3d85

    Wanting confirmation... Rear wheel ticking...

    So as of now no more tick, I appreciate everyone and the input and help! A side note be very cautious when asking Google AI for help or information... Google had told me to run that sprocket dry... Bastard technology...
  10. JaR3d85

    Wanting confirmation... Rear wheel ticking...

    I couldn't source any hp222 or xhp222 locally but I did get some sta lube staplex extreme pressure that is very very close on all the specs and exceeds some areas labelled, the only thing that is that far off is is temp rating and its only off by 36 degrees.
  11. JaR3d85

    Wanting confirmation... Rear wheel ticking...

    So I am wondering something else are we running rear wheel "sprocket to bevel box dry? Like no grease ?
  12. JaR3d85

    Wanting confirmation... Rear wheel ticking...

    Absolutely, I have new wheel bearings on the way, the guy who had the bike before me had overfilled the break reservoirs, the oil and the final drive... When I last had the wheel off about 1k miles ago there was gear oil on the axle and some leaking from the opening on the bottom the the final...
  13. JaR3d85

    Wanting confirmation... Rear wheel ticking...

    Just want to confirm that I'm correct in assuming my rear wheel clicking when rolling is most likely the wheel bearings, happens backwards and forwards it takes a second for it to click rolling backwards after rolling forward assuming bearings are taking a second to catch again goimg the...
  14. JaR3d85

    After market mirrors

    I actually just purchased some 2010 triumph thunderbird mirrors, they sit quite a bit lower than the Mickey mouse ears on my 2014 roadster they are by no means smaller on the mirror but I think they will look a lot better . I attached a pic just for reference on what style. They are about half...
  15. JaR3d85

    Looking for some visual confirmation

    Thank you turbo! I took it for a spin the wheels that were on before were 7 year old avom cobra chromes, these metzlers feel way different, I will be able to give them a fair crack after I break them in a bit more .
See more
Back
Top