Want to Buy WTB, 1st gen seat w/driver backrest

[Ishrub]

Found the info now to find one! @Brennus

Corbin Motorcycle Seats & Accessories | Triumph Rocket III | 800-538-7035

Corbin Motorcycle Seats, Saddles, and Accessories Online

www.corbin.com

Rider Seating: 15" wide x 15.5" long
Passenger: 13" wide x 14" long
Approx. seat height: 27"

Brackets are shown yellow for illustration purposes only. Actual brackets come prepainted black.
Corbin Motorcycle Seats & Accessories | Triumph Rocket III | 800-538-7035





Installation: Dual Touring Saddle installs easily with brackets included. Installation is slightly different than your stock seat to provide the strength needed to support the integrated backrest system. Notice also we do not use a snorkel over the airbox and instead let the bike pull air from the entire under seat area (this actually frees up airflow). Since the Corbin basepan forms over the edges of the frame, you needn't worry about water intrusion either.

Simply install the Corbin bracket onto your fender with the included bolts. This provides the mounting points needed to mount the Dual Touring saddle. We recommend the use of Loctite or other threadlock compound and torque these bolts to 8 ft lbs. If using a heated model, you will also need to connect the wiring pigtail to your fusebox.

Now lower the seat into position with the tongue in the front and the side mounts lining up with the bracket you installed earlier. Secure with the included chrome button head bolts using a little Loctite and torque them to 6 ft lbs. You're ready to roll. Complete instructions included.

We recommend removing the seat from the bike when washing. In the case of the Rocket III, remember to cover your airbox when doing this to stop water from getting into the airbox!

 

[Ishrub]

The Corbin Solo Classic uses the Triumph seat post spike to locate.

Corbin Motorcycle Seats & Accessories | Triumph Rocket III | 800-538-7035

Corbin Motorcycle Seats, Saddles, and Accessories Online

www.corbin.com

Rider seating: 14.5" wide x 15" long
Rider back support w/ #02-S: 12" - 13"
Approx. seat height: 27"

Installation: Installation of the Corbin Classic Solo saddle is simple and works on your stock Triumph key lock system. Mounting brackets come premounted on the seat so you're ready to roll right out of the box.

Simply remove your stock seat and slide the Corbin saddle into its place. Locate the tongue in the front of the saddle into the bracket on your frame and lower the latching pin into place in the Triumph bracket. Notice our bracket is designed with a double latch, so listen for TWO clicks.

To adjust the position of the Corbin backrest, just insert the backrest shaft into the hardware and align the threaded hole in the shaft with either of the two openings in the Corbin basepan. The hole closer to the top of the saddle will move the backrest up and rearward roughly 3/4 inches. Now tighten the safety screw securely. We also recommend the use of a light grip threadlock material like Loctite Blue in this instance.

To ease installation until the rubber bumpers on the basepan break in, it may be necessary to add a couple washers between the Corbin basepan and latch pin.
We recommend removing the seat from the bike when washing. In the case of the Rocket III, remember to cover your airbox when doing this to stop water from getting in!

 

[Ishrub]

I'm hunting for one now too!